Lume: NAT doesn't seem to work, DNS not reaching local network

[CamJN]

I cannot ssh into my guest/VM from the host running lume, it hangs until I kill the command. It appears to be using a NAT network because the ip address of the guest isn't from my router's dhcp's address range. I also verified that the firewall is off on the guest, and that ssh is enabled.

Is there a way to ssh into the guest vm from the host? I don't see anything about networking anywhere in the docs.

running ping and traceroute for the ip from the host works.

there are no messages in the console for sshd on the guest.

I can ssh into the guest from the guest over the loopback interface and the 192.168.64.2 IP.

[CamJN]

More strangeness:

I rebooted the vm and was able to ssh in but then no other internet worked. The vm wasn't able to access the internet at all while I was connected. It seems as though the vm can only make one network connection at a time?

Ok the problem there was that the dns wasn't working, when I changed the dns for the ethernet connection to my network's dns ip it started working.

So that points at the strange nat setup as the problem? Is there any way I could read about how the networking is handled in lume?